Instructions for use:
Connect the power supply and equipment, the measuring temperature is displayed, press the “SET” button, press ” + or – ” to set the desired temperature (long press ” + or – ” to quickly increase or decrease), press the “SET” to confirm the setting and return, controller automatically performs the relay ON/OFF.
LED Indicator: LED off indicates the relay off; Lighting, indicates the relay is closed.

Digital LED Tubes: “LL” indicates sensor open, “HH” indicates overrange, the relay will be forcibly disconnected; “—” indicates high temperature alarm
Long press the “SET” button to enter the main menu settings,
press ” + or – ” to switching between P0-P6,
then long press “SET” or 10 seconds without keystrokes to confirm the setting and return.
the thermostat output is 10A relay, meet a variety of high-power loads.
 
Specifications:
Temperature Range :-50 – 110 degree centigrade
Resolution: When temperature is 0.1 degree, the resolution is -9.9~99.9, other temperature segment is 1 degree.
Refresh Rate: 0.5s
High Temperature Protection 0 – 110 degree centigrade
Supply Voltage: DC 12V
Static Current: Less than 35MA, attract current less than 65MA
Output Voltage: DC 12V
Output Power: 20A relay
Measurement Input: NTC (10K 0.5%) Waterproof Sensor
 
Buttons:

P0 :Cooling / Heating; Range: C/H; Default: C
P1 :Hysteresis Setting; Range:0.1-15; Default: 2
P2 :Highest Setting Limit; Range:110; Default: 110
P3: Lowest setting Limit; Range:-50; Default: -50
P4 :Temperature Correction; Range:-7-7°c; Default: 0°c
P5: Delay Start Time; Range:0-10 Minute; Default: 0
P6: Key Tone Switch; Range:0-110; Default: Off
When the Thermostat is power off, long press “- or +”, you can restore the factory settings